Type the host's fully qualified domain name in the /etc/defaultdomain file.įor example, suppose host tenere was part of the domain.(Optional) Add the IP address or addresses of the file server, if the.Were added to the local host after installation. (Optional) Add the IP addresses and corresponding names for any network interfaces that.Make sure that the existing entries in /etc/inet/hosts are current.The Oracle Solaris installation program creates entries for the primary network interface, loopbackĪddress, and, if applicable, any additional interfaces that were configured during installation. Verify that the entries in the /etc/inet/hosts file are current.Nicknames are additional names by which an interface is known. Use the following format for entries in the /etc/inet/ipnodes file: IP-address node-name nicknames. Of every interface that is configured during installation. This fileĬontains the node name and IPv4 address, and IPv6 address, if appropriate, The Oracle Solaris 10 installation program creates the /etc/inet/ipnodes file. For Solaris 10 11/06 and earlier releases, verify that the entries in.However, if you later want toĪdd more interfaces to the system, you must manually configure them. One interface during Oracle Solaris installation. If you configured additional interfaces during installation, verify that each interface hasĪ corresponding /etc/hostname. Interface and any other interfaces that you optionally configure at installation time. The installation program creates an /etc/hostname. The first interface that you configure automatically becomes the The Oracle Solaris installation program requires you to configure at least one interface file, refer toīasics for Administering Physical Interfaces. interface file exists for each network interface on theįor file syntax and basic information about the /etc/hostname. Name entry is the correct host name for the system. That host name is entered into the /etc/nodename file. When you specify the host name of a system during Oracle Solaris installation, Verify that the correct host name is set in the /etc/nodename file.To create the roleĪnd assign the role to a user, see Chapter 2, Working With the Solaris Management Console (Tasks), in System Administration Guide: Basic Administration. The Primary Administrator role includes the Primary Administrator profile. Assume the Primary Administrator role, or become superuser.Releases, refer to How to Configure a Physical Interface After System Installation. Use this procedure for configuring TCP/IP on a host that runs inįor steps for manually configuring interfaces in Solaris 10 11/06 and subsequent How to Configure a Host for Local Files Mode See System Administration Guide: Naming and Directory Services (DNS, NIS, and LDAP)įor information on working with name service databases. This chapter contains information on creating and editing local configuration files. See Oracle Solaris 10 9/10 Installation Guide: Basic Installations. System, you can optionally configure the additional interfaces during installation. If the Oracle Solaris installation program detects more than one interface on the Subnet mask (required only for networks with subnets). For more information on default routers, refer to Packet Forwarding and Routing on IPv4 Networks See Table 5-1 for a list of routing protocols supported in Oracle Solaris. You also supply this information if your routers do not run routing protocols such as the Router Discovery Server Protocol (RDISC) or the Router Information Protocol (RIP). You supply this information if you have a simple network topology with only one router attached to each network. The NIS, LDAP, or DNS domain name in which the system resides, if applicable. You can type the host name in a local file or a name service database. The host names of each system on the network. The IP address of each network interface on every system. The parameters that are supplied during network configuration follow: The availabilityĭepends on whether these files are stored locally (local files mode) or acquiredįrom the network configuration server (network client mode). HowĬonfiguration information is made available to a system's kernel is conditional. The network configuration process involves creating or editing the network configuration files. Network software installation occurs along with the installation of the operating system software.Īt that time, certain IP configuration parameters must be stored in appropriate files
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |